Miramar Is Complete!

Images via New York Yimby

Miramar at 405-407 West 206th Street

Inwood, Manhattan NY

Architect

Beyer Blinder Belle

Engineer

DeSimone Consulting Engineering

Contractor

King Contracting

FERO Products Used

FAST Thermal Bracket^™ Offset Shelf Angle Support - Standard and Lintel Brackets

We're excited to see the completed façade on Miramar, two interconnected, mixed-use buildings that include residential apartments, retail space, and a performing arts center in Inwood, Manhattan. Designed by Beyer Blinder Belle, the building will provide 698 units, with nearly 85,000 square feet of indoor and outdoor amenities.

Our FERO FAST Thermal Bracket™ - Standard, and FAST Thermal Bracket™ Offset Shelf Angle – Lintel, provided an offset shelf angle design on this project, substantially reducing the quantity of steel required for brickwork support compared to traditional shelf angles. This not only sped up installation and reduced costs, but also enhanced the energy efficiency of the entire masonry wall assembly.

Back to Project Profiles

Overview

Greenpoint Landing is a 22-acre master-planned development site located on the Brooklyn waterfront with a view of the Manhattan skyline, bringing a mix of ten residential towers and low-rise buildings, a new public school, and four acres of parkland. The buildings are located on reclaimed industrial use lands, and the brick veneer utilized in the building design provides continuity with the historical neighborhood.

Challenges

For the brick on the Greenpoint Landing F1 tower, the design team was targeting an energy efficient “thermally broken” shelf angle system, and had originally specified a Halfen cast in anchor with knife plate system (Figure 1 and 2). Spacing of the angle knife plate system was specified at 18” on centre for 4,326 linear feet of relieving angle, requiring approximately 2,884 units.

Solutions

In an effort to reduce costs, the contractor suggested a FERO FAST bracket solution (Figure 3) for offsetting the shelf angle.

As FERO became involved at a later stage in this project, the FAST bracket solution needed to accommodate existing wall cavity specifications from the architect, Handel and DiSimone.

FERO was able to accommodate these using custom FAST brackets with a depth of 3-3/16”, slot modified for ¾” bolts and supporting a 4x4x5/16” angle. This project highlights the cost saving proposition of FERO Fast Brackets, as the switch to FAST saved on both material (eliminating more than 1,000 units of the original spec, using only 1,800 FAST Brackets) and labor costs, as the FAST brackets could be quickly installed by a single trade onsite.

Result

FERO’s technical team is available to support designers and contractors in value engineering their projects to reduce costs. On this project, the structural support offered by FAST Brackets allowed for increased spacing and reduced material costs. Additional savings could have been achieved if the anchor channels were not already installed, as the horizontal and vertical adjustability included with FERO Fast Brackets makes such channels redundant. Our team will work with your project specs to ensure costs are minimized through use of the most efficient spacing, anchorage and shelf angle size.

FIG 1